Help > Telephoning > Call
Call
*Further help under Call and transfer
Display overview: Active conversation 
aStatus Connected.
bIdentity of called SUB
cOwn identity
dEnd
eConversation duration
Putting a call on hold 
Active call > Hold
or
OK
Reconnecting an on-hold call 
To do this, press Hold again
or
press OK again.
Accepting a call 
During an active call, the LED on the key with the Speed dialling function assigned to it shines red. Press the key with the Speed dialling function assigned to it to pick up the call.
*Note: This function is useful, for example, in the case of answering machines. The prerequisite is that call takeover is permitted in the PBX.
*Consult the PBX manual for this.
Muting a call 
Microphone
Switching off muting 
To do this, press Microphone again
Ending a call 
To do this, hang up the receiver
or
Softkey End
*Note: If you want to end the current call, and then immediately make a new call, press the soft key End and then start dial the next number.
*Note: When your call partner ends the call, your phone goes into its idle state. If you hang up the receiver, you will hear the busy signal through the base unit loudspeaker if the receiver has been hung up incorrectly.
Sending a DTMF signal during a call 
To do this, enter digits and special characters
*Note: The selected numbers and characters are displayed in the screen for some seconds and you can hear the associated sound.