Manual commissioning on the PBX
To operate the telephone, it is essential to set up an identity (here: PBX). You need the following information:
•The internal number configured for the phone (Example: 557) → SIP Username
•The associated password → Password
•The PBX's IP address (Example: 192.168.196.37) → SIP Registrar
1.Connect the telephone.
The Message key flashes.
The company logo is first shown on the display for 2 - 3 minutes, followed by the information that provisioning data is being searched for.
The IP address of the phone is shown at the top right of the display.
2.Write down the IP address.
Note: Make the settings afterwards as follows:
•Navigate/select: cross control
,
•Enter: Keypad
3.Set the language and location.
−Softkey Country > Phone language
−Location
−Web interface
4.Optional: Switch back to the initial setup menu and activate access to the web interface.
5.Set up the identity and activate the identity.
−Softkey Menu > Settings > Identities > 1:
−SIP Username
−Password
−SIP Registrar
−Active
The phone registers at the PBX and is then ready to use.